Spray Foam Insulation in Green Bay, WI

Spray foam insulation in Green Bay usually goes into three places: the rim joists in the basement, the attic, and any room that sits over a garage or porch. The city counted 45,789 housing units in 2020, and they cover more than a century of building, from houses near the paper mills and downtown to subdivisions on the far east and west sides. The approach changes with the age of the house, but the goal is the same: stop warm air leaking out and cold air leaking in.

Older neighborhoods

In houses built before the 1960s we often find attics with a few inches of old fill, open rim joists and walls with little or no insulation. Sealing the attic floor, foaming the rim and dense-packing walls where it makes sense brings a drafty house up a long way. We check wiring before filling any wall.

Mid-century and newer homes

Ranches and split-levels from the 1950s through the 1980s tend to have shallow attics with recessed lights and bath fans that leak. Newer homes have better attic depth but often leave the rim joist and bonus-room kneewalls weak.

Owners and landlords

Census QuickFacts shows about 58% of Green Bay homes are owner-occupied, so a good share of our calls come from landlords who want lower heating bills and fewer tenant complaints about cold rooms. We quote rentals the same way: area by area, in writing.

Costs for a city house

National guides put a rim joist foam job at about $2,000 to $2,500 and a typical attic insulation job at $1,000 to $2,700 (HomeGuide). City lots often have tight driveways and detached garages at the alley, which can affect hose runs and setup, so we note access on the quote. You get one written number per area.